Visit Talon Tunes
Updated on September 12, 2007
white-anaconda
Participant
September 12, 2007 at 6:55 am
Q:

REMOVING SAFETY SEAR?

i have removed the safety sear on my stealth,but after it would not stay cocked,i have not got a pre load screw so maybe my stealth is the old model,anyway put the sear back minus the little safety spring,and its ok except due to extra strong spring makes it hard to disengage safety now,anybody know why it would not cock without sear as i need to remove it?

Mods/Machinists

All Replies

Viewing 2 replies - 1 through 2 (of 2 total)

white-anaconda
Participant
September 12, 2007 at 8:30 am

thanks bud,think i got it,

y
Participant
September 12, 2007 at 7:04 am

Move spring 184 forward (to the right in that picture) into the long channel right under the end of the sear (The spring wont move even tho the slot is longer than the springs diameter).

If my directions dont make much sense I’ll take a picture of my guns spring locations when I get out of work and that should explain it better.

Viewing 2 replies - 1 through 2 (of 2 total)

  • You must be logged in to reply to this topic.